TERP PEN SPECTRUM

The Terp Pen Spectrum can be used right out of the box, although it is recommended to fully charge the unit prior to use. Included with the Terp Pen Spectrum are two coils, a ceramic dual rod with stainless steel wire and a quartz single rod with a Clapton coil wrap. To “turn on” the unit, remove the magnetic cap and screw in one of the coils tight to the battery.

*Important – 5 consistent taps near the USB-C port will change the voltage. The voltages will cycle from 3.3V (green), 3.7V (blue), and 4.0V (red). 

OUT-THE-BOX USAGE:

Inhale on the mouthpiece to activate the coil. The coil will begin to heat as soon as inhalation has started and will increase in heat the longer the inhalation time is. After 12 seconds of continuous inhalation/heating, the coil will stop getting hot. To restart heating, stop inhalation, breathe out, and inhale again.

*It is recommended to perform a dry “burn-off” on a fresh coil to sanitize it. To do this, remove the middle cover while keeping the coil attached to the battery. Begin to inhale on the unit and heat up the coil. The air path is no longer connected when the middle cover is removed. This will allow any material that may be on the coil to “burn-off” into the air. Reconnect the middle cover to proceed with using the device. This method can also be used to clean the coil or heat up any concentrate build up prior to cleaning.